Under-Sink and Countertop Systems

Do You Need an Air Gap Faucet for an RO System?

Learn what an air gap faucet does for a reverse osmosis drain, when local plumbing code requires one, and why a check valve is not a substitute.

On this page
  1. What an air gap does
  2. Why RO systems send drain water to the sink
  3. Do you need one? It depends on local code
  4. Air gap faucet vs non-air gap faucet
  5. Why a check valve is not a substitute
  6. If you do not have room for an air gap faucet
  7. Checking with your local inspector

What an air gap does

An air gap is a physical break between the RO drain line and the sink. Drain water from the RO system leaves the faucet’s separate drain outlet, falls through open air, and then enters the sink. Because there is open air between the two, water from a clogged or flooded sink cannot flow back up into the RO drain line.

That open gap is the point. It stops contaminated water from reaching the part of the system that feeds your drinking water.

Why RO systems send drain water to the sink

Reverse osmosis produces a steady stream of wastewater, which carries the contaminants the membrane has removed. The drain line has to go somewhere. Many systems send it into a drain fitting on the sink, a standpipe, or a dedicated faucet with an air gap built in.

Where the drain connects directly to the sink’s drain pipe with no break, a clog can back water up into the line. This is the backflow risk that plumbing codes are written to prevent.

Do you need one? It depends on local code

There is no single national answer. Local plumbing codes decide whether an air gap or another approved backflow device is required. Many places require one. California is one example that is often cited. Some areas accept other approved methods. A few do not allow the direct connection most under-sink systems use.

To find your answer:

  • Ask your local building or plumbing inspector, or check the permit office’s website.
  • Ask whether a permit is needed for the RO installation.
  • Confirm that any separate faucet or fitting you buy is approved for the purpose in your area.

Air gap faucet vs non-air gap faucet

An air gap faucet is a faucet that has the air gap built into its base or cover. It usually comes with a separate drain outlet. It is the simpler route when code requires it.

A non-air gap faucet has no built-in air gap. Some are quieter and more compact, and some need fewer parts. Whether a non-air gap faucet is allowed depends on your code. Do not assume a faucet with fewer parts is an acceptable choice without checking.

Why a check valve is not a substitute

Some DIY posts suggest a check valve on the drain line in place of an air gap. A check valve lets water flow one way, but it is a mechanical part that can fail. An air gap is a physical break that does not rely on a moving part. For this reason, many plumbing authorities do not accept a check valve as an approved backflow device for RO drains.

If you are told a check valve is “just as good,” ask the inspector to confirm in writing.

If you do not have room for an air gap faucet

Some kitchens have no space for a second faucet. Options to discuss with a plumber or inspector include:

  • Moving the RO system to a bar or utility sink with its own drain.
  • Using a separate sink or faucet dedicated to drinking water.
  • Confirming whether a code-approved fitting could work in your setup.

Do not run the drain line through a wall or into an outdoor drain without checking first. Local code may treat that differently, and it can create a new problem if the drain is not designed for it.

Checking with your local inspector

Before you cut or drill, take three things to the inspector: the RO system’s installation manual, the drain fitting that comes with it, and a sketch of the sink. Ask what they accept for the drain, and whether an air gap is required. Get the answer in writing if you can. The rule that applies to your home is the one the local inspector enforces.

For background on how RO systems work and what they remove, see reverse osmosis pros and cons. For the installation itself, see how to install an under-sink reverse osmosis system and how big a storage tank an under-sink RO needs.

The complete guide to under-sink and countertop systems

Drinking Water Filtration Systems Compared: Under-Sink and Countertop
Read the guide

Keep exploring

Guides from other topics

All topics →