Short answer
You cannot tell whether bore water is safe by looking at it, smelling it or tasting it. Harmful bacteria and many chemicals, including nitrate, are invisible and often tasteless. Only a laboratory test can confirm safety. Until you have results, treat the water as unverified, especially if anyone in the household is an infant, pregnant, elderly or immune-compromised.
What to test
Use an accredited laboratory. State health departments and university extension programs can often recommend one.
- Total coliform bacteria and E. coli. Test at least once a year. These indicate whether the water has been contaminated by surface or waste water.
- Nitrate. Test at least once a year. Nitrate has no taste or smell.
- pH, hardness, iron, manganese and hydrogen sulfide. These affect taste, staining, scale and corrosion.
- Total dissolved solids (TDS). A general measure of dissolved minerals and salts.
- Local concerns. Depending on the area, arsenic, lead, uranium, radon or pesticides may also be relevant.
Warning signs
Test promptly if you notice any of these:
- Cloudiness, sediment or a change in color.
- A rotten egg smell, or a metallic or bitter taste.
- Staining on fixtures or laundry.
- A sudden change after heavy rain, flooding or nearby construction.
- Nearby septic systems, livestock, fertilizer use or fuel tanks.
- Illness in the household that might be linked to the water.
Absence of these signs does not prove the water is safe. Warning signs tell you to test sooner. They do not tell you the water is clean.
Protect people at higher risk
Nitrate above the health limit can harm infants. The EPA limit for nitrate is 10 mg/L, measured as nitrogen. Water with nitrate above this level should never be used to make formula for infants under six months old. Use bottled water for infants until results are back and treatment is in place. Ask your doctor for advice about pregnancy, breastfeeding and young children.
What to do while you wait
- Boil the water for bacteria concerns: a rolling boil for one minute, or three minutes at high altitude. Boiling does not remove nitrate, metals or chemicals.
- Use bottled water for drinking, cooking and infant formula until the results are back.
- Avoid using the water for drinking if a bacteria result is positive and you have not yet disinfected the well.
Read the results
- Positive for total coliform or E. coli. Do not drink untreated water. The well and plumbing need disinfection and an inspection to find the cause. A well contractor or the health department can advise on next steps. Shock chlorination is one option for a one-time problem.
- Nitrate above 10 mg/L. Use an alternative drinking source, and consider treatment such as reverse osmosis. See how to remove nitrates from well water.
- Iron, manganese or sulfur above guidelines. These affect taste and staining, not usually acute health, but they still need treatment.
Check the well itself
A water test shows the result, but the well’s construction affects future risk. Check for:
- A cap or sanitary seal that is intact and locked.
- Casing that extends above ground and is sealed.
- No cracks, open vents or debris around the wellhead.
- Distance from septic systems and livestock that meets local code.
A licensed well contractor can inspect the well and recommend repairs. Repair or sealing may be needed before any treatment will be reliable.
When to call a professional
Call a water treatment professional or well contractor if the results are positive, the source is unclear, or the water quality changes suddenly. Ask for a written explanation of what was found and what will be done.
For how to treat the water once you know what is in it, see how to filter well and bore water for drinking.