Short answer
The most common way to remove nitrate from a home water supply is reverse osmosis (RO) at the drinking tap. For a whole-house supply, anion exchange with a nitrate-selective resin is the usual choice. Boiling does not remove nitrate and makes it more concentrated. Standard water softeners do not remove it either.
Why nitrate matters
Nitrate in drinking water is measured against an EPA limit of 10 mg/L, expressed as nitrogen (nitrate-N). Nitrate above this level can cause methemoglobinemia, sometimes called blue baby syndrome, in infants. Water above the limit should not be used to make formula for infants under six months old. Use bottled water for infants until the water is treated and retested.
Nitrate can come from fertilizer, animal manure and failing septic systems. It often rises after heavy rain or during periods of heavy fertilizer use, so one good result does not guarantee the next.
You cannot see or taste it
Nitrate is colorless, odorless and tasteless. A glass of water with high nitrate looks and tastes the same as one with none. Only a lab test shows the level. Test at least once a year, and retest if the well, the nearby land use or the household changes.
Options that work
- Reverse osmosis at the drinking tap. An under-sink RO unit removes most nitrate from the water it treats. RO needs a pre-filter, a storage tank and some drain water. Look for a unit certified for the contaminant you are treating, and retest the water after installation.
- Anion exchange for the whole house. A nitrate-selective resin exchanges nitrate for chloride or another ion. It needs periodic regeneration with salt and proper disposal of the brine. It is more complex and costly than RO at one tap, so get a sizing check from a specialist.
- Distillation. Distillation works by boiling water and collecting the steam, which leaves nitrate behind. It is slow and uses energy, so it is practical only for small volumes such as drinking water.
Blending high-nitrate water with low-nitrate water is not a reliable fix, and it should not be done without expert advice.
Options that do not work
- Boiling. Boiling removes bacteria but concentrates nitrate as the water evaporates.
- Carbon filters and pitcher filters. These do not remove nitrate.
- Standard water softeners. Softeners exchange sodium for calcium and magnesium. They do not remove nitrate.
- Sediment filters. These remove particles only.
Keep infants and the household safe while you treat
- Use bottled or treated water for formula and infant drinks.
- Keep the treated tap separate and clearly labeled, so no one uses untreated water by mistake.
- Test the treated water after installation, and check the system on a regular schedule.
Find the source
Nitrate in a well often points to a nearby source. Ask a licensed well contractor to check the well construction and the surrounding land. Check for fertilizer use nearby, animal manure, septic systems and cracks or openings in the well cap or casing. Fixing the source reduces how much treatment you need over time.
Testing and retesting
- Test nitrate and total coliform at least once a year.
- Retest after installing any treatment, and after filter or resin service.
- Keep the lab report, because it shows the baseline you need for comparison.
For the full treatment order, including sediment and disinfection, see how to filter well and bore water for drinking. For the bacteria side of testing, see how do I know if my bore water is safe to drink.