Short answer
Reverse osmosis (RO) water is often slightly acidic, commonly with a pH somewhere around 5 to 7. The main reasons are that RO removes the minerals that normally buffer pH, and that carbon dioxide from the air dissolves into the water and forms weak carbonic acid. This is normal for RO water and does not mean the water is contaminated. Slight acidity can affect taste and, in some plumbing, corrosion, so some people add minerals back to adjust it.
Why RO water is often slightly acidic
Natural water contains dissolved minerals, such as calcium and magnesium, that act as a buffer. A buffer resists changes in pH. RO removes most of those minerals, so the water has little buffering capacity left.
Carbon dioxide is the second factor. Water in contact with air absorbs some carbon dioxide, which forms carbonic acid and lowers the pH. RO membranes do not remove dissolved gases well, so the carbon dioxide stays in the water. With little buffer to resist it, the pH can drift lower.
The pH of RO water also depends on your feed water and on how the system is built, so the reading can vary from one home to another.
Is slightly acidic RO water harmful?
For most healthy people, typical variations in drinking water pH have not been shown to cause significant health effects. Some people believe acidic water causes acid reflux, but there is little good evidence for that effect from drinking water.
Health claims for alkaline water, such as improved digestion, weight loss, or disease prevention, are generally not well supported by research. If you have kidney disease or another medical condition, check with your doctor before changing your drinking water.
Taste
Slightly acidic, low-mineral water can taste flat, and some people notice a slight tang. Taste is subjective, so the only way to know how your water will taste after an adjustment is to try it. For the options, see our guide to remineralizing RO water.
Plumbing and corrosion
This is the more practical concern. Water with low alkalinity and a low pH can be more corrosive to some metals than water with more minerals. In homes with copper pipes, fixtures, or older plumbing, that corrosion can release metals into the water over time. Lead solder in older plumbing is a particular concern.
If your home has copper pipes or older plumbing and your RO water tests well below neutral, ask a water professional to look at it. They can check the pH, the alkalinity, and the metal levels in the water. Do not assume that a particular fix will solve the problem without testing.
How to measure pH correctly
Several methods are available:
- Test strips are inexpensive and easy to use, but they are less precise.
- Digital pH meters are more accurate, but they need regular calibration.
- A laboratory test gives the most reliable result, and it can include alkalinity and metals.
Measure fresh water straight from the faucet. If you pour the water into an open glass and wait, carbon dioxide moves in and out of the water, and the pH changes. A reading taken after the water has sat out may not match the water that comes from your faucet.
Adjusting the pH
The usual approach is a remineralization stage after the membrane. A calcite or calcite-magnesium cartridge adds calcium and raises alkalinity, which raises the pH and makes it more stable. Some people use mineral drops or alkaline pitchers instead. Follow the product’s instructions, and check its specification sheet for the expected pH range.
Salt is not a reliable way to adjust pH. It adds sodium, and it does not raise pH in a predictable way. For more on this, see how to add minerals to RO water naturally.
Make sure the post-carbon filter is current too, because it handles the polishing stage. See what the post-carbon filter does in an RO system.
When to get help
Ask a water professional for help if your RO water tests well below neutral and your home has copper or older plumbing, if you notice a metallic taste or staining, or if your system has been adjusted and the pH has not changed as expected. For the broader picture, see the reverse osmosis pillar guide. For how total dissolved solids relate to the water you drink, see what TDS level reverse osmosis water should be.