Short answer: Osmosis is the natural movement of water across a semipermeable membrane, from the side with fewer dissolved particles to the side with more. It needs no energy input. Reverse osmosis applies pressure to force water the other way, from the side with more dissolved particles to the side with fewer. That pressure is why home RO systems need enough water pressure to work.
Osmosis: the natural process
A semipermeable membrane lets some molecules pass but blocks others. Water molecules can pass through, while many dissolved salts and larger particles cannot. If you put fresh water on one side of such a membrane and salty water on the other, water moves through the membrane toward the salty side. It does this on its own, and it keeps going until the concentrations start to balance or the pressure on the salty side stops the flow.
Osmosis happens in living things, too. Plant roots take up water from soil partly through osmosis.
Reverse osmosis: adding pressure
Reverse osmosis reverses the natural direction. Pressure is applied to the side with dissolved particles, and that pressure must be higher than the natural osmotic pressure. Water is then pushed through the membrane toward the fresher side. The dissolved salts and most other contaminants stay behind on the pressurized side.
In a home system, the water that passes through the membrane is called permeate, and it is the water you drink. The water that carries the rejected material goes down the drain as reject water. The membrane does not catch everything on its own, which is why RO systems use prefilters and a carbon filter as well.
Key differences
| Osmosis | Reverse osmosis | |
|---|---|---|
| Direction of water flow | From fewer dissolved particles to more | From more dissolved particles to fewer, pushed by pressure |
| Energy needed | None; it happens on its own | Pressure must exceed osmotic pressure, usually from water pressure or a pump |
| Where it happens | Natural processes, including in plant roots | Engineered systems, including home water filters and desalination plants |
| Typical use | Biology and natural processes | Drinking water treatment and desalination |
What reverse osmosis leaves behind
Reverse osmosis removes most dissolved salts, including calcium and magnesium. It also removes many contaminants, such as lead, arsenic, nitrate, and fluoride, depending on the membrane and the system. These leave with the reject water, not in your glass.
Because the membrane removes minerals along with contaminants, RO water often tastes flat. Some people add minerals back afterward. See our guide to remineralizing RO water for the options.
RO is not a complete treatment for every kind of contamination. Chlorine and some organic compounds are reduced mainly by the prefilters and the carbon filter. The membrane alone is not the whole system.
Why this matters when you choose a water filter
When you read about a home RO system, the words “reverse osmosis” tell you the system needs pressure. A typical under-sink system depends on your home’s water pressure, which means very low pressure can slow it down. Check the manufacturer’s stated pressure range before you buy.
For a broader look at how RO compares to other options, including distilled water, see reverse osmosis vs distilled water. For the full picture of RO’s strengths and limits, read the reverse osmosis pillar guide.