Short answer
You can remineralize reverse osmosis (RO) water with a remineralization filter, an alkaline pitcher or inline cartridge, or mineral drops. Sea salt is a popular tip, but it adds mostly sodium and only small amounts of other minerals. If you want to add minerals, a filter or measured mineral drops give more predictable results with less sodium.
Why RO water needs remineralizing
A reverse osmosis membrane removes most dissolved salts, including calcium and magnesium. Without them, water often tastes flat, and its alkalinity is low, so its pH can sit below neutral. Many people remineralize mainly for taste. Some want to restore small amounts of calcium and magnesium, but food is the main source of those minerals.
Ways to remineralize RO water
Remineralization filter (calcite, or calcite with magnesium oxide)
This is a cartridge installed after the RO membrane. Calcite is calcium carbonate, and it slowly adds calcium and raises alkalinity. Blends that include magnesium oxide also add magnesium and adjust pH faster. The cartridge works automatically, so you do not need to measure anything.
Cartridge sizing matters. If the pH rises too high, the water can taste different, so choose a cartridge that fits your system and follow the specification sheet.
Alkaline pitcher or inline alkaline filter
An alkaline pitcher holds a mineral cartridge that adds minerals as you pour. An inline alkaline filter is installed on an RO system and works without you doing anything. Pitchers cost less to start with. Inline filters are more convenient for daily use. Compare the replacement interval and the cost of replacement cartridges before you choose.
Mineral drops or tablets
Mineral drops and tablets let you adjust the taste glass by glass. They are low cost and need no installation. The drawback is consistency: if you forget a dose, the taste changes. Use the dose on the label, and add it the same way each time.
Sea salt and pink Himalayan salt
Sea salt and pink Himalayan salt are mostly sodium chloride. They contain small amounts of other minerals, but a pinch in a glass adds very little calcium or magnesium. To add a meaningful amount of those minerals this way, you would need to add a lot of salt, and that much salt adds a lot of sodium. The pink color or the “sea” label does not change this.
If you are watching your sodium intake, skip salt. If you choose to use it anyway, use very small amounts and count it toward your daily sodium. For a broader look at salt-free and food-based options, see our guide to adding minerals to RO water naturally.
What to check before you buy
- Certification. RO systems are commonly certified under NSF/ANSI 58. Many taste and aesthetic cartridges are certified under NSF/ANSI 42. Check the certification for the exact product, because a system’s certification does not automatically cover an add-on cartridge.
- Specification sheet. Look for the expected pH range, mineral additions, capacity, and replacement interval. These details vary by product.
- Fit and flow. Check that the cartridge fits your housing and that it will not slow the flow more than you expect.
Maintenance
Remineralization cartridges need replacing on a schedule. Intervals vary, so use the number on the specification sheet rather than a general figure. Replace the cartridge on time, because an exhausted cartridge stops adding minerals and may change the taste. For the RO membrane itself, see our article on how often to replace an RO membrane.
Who should be careful
- People on a low-sodium diet should avoid salt-based methods.
- People with kidney or heart conditions, or who take medicines that affect minerals or fluids, should ask their doctor before changing their drinking water.
- Infant formula needs its own check. Our article on RO water and baby formula covers that.
If you are not sure which method to use, start with a remineralization filter or mineral drops, and check the taste after a couple of weeks. For the broader trade-offs of RO water, see the reverse osmosis pillar guide.